Description
Features
As compared to the original formula:
✅ Fully improved formula
✅ 30 percent faster stain removal
✅ 30 percent better embedded stain removal
✅ Foaming ability
✅ Stronger R|E™ neutralization
✅ Double shelf life
For mold, water, fire, biohazard, and exterior remediation services.
Compatibility
Suitable for most construction materials including treated and untreated lumber, OSB, particle board, masonry, concrete, brick, wallboard, painted surfaces, and composites.
Common applications include sheathing, trusses, framing, joists, plates, beams, posts, and studs.
Combine with SorbAssist to leave a fresh, clean fragrance.
Combine with SpeedZero to penetrate especially hard or cold surfaces.
Compatible with:
✅ Enviroguard Cleaners & Stain Removers
✅ Dutrion Tablets & Powders
✅ Enviroguard Equipment
✅ FOAMiT Equipment
✅ Premira Equipment
✅ Titan Tool Equipment
Coverage
Used alone as a cleaner, OxyPrep provides an estimated 150 to 300 square feet of coverage per ready-to-use gallon depending on surface texture, porosity, and application method.
As Part 1 of React|Extract™ OxyPrep will yield up to 400 ft2 per ready-to-use gallon.
Estimates do not account for loss from overspray or heavy application.
Instructions
As a Mold Stain Remover Only
- Apply OxyPrep to the point of saturation.
- Allow a dwell time of 30 to 60 seconds.
- If stains remain, reapply to the targeted areas.
As Step 1 of the REACT|EXTRACT™
- Apply OxyPrep to the point of saturation.
- Allow a dwell time of 30 to 60 seconds.
- Neutralize with OxyPar LR or SuperPar.
- Allow neutralized foam to absorb the soil load for up to 5 minutes.
- Wet vacuum extract.
- Repeat if necessary.
R|E™ Fire/Water/Biohazard Cleanup
- Combine OxyPrep and PreClean in a 50/50 ratio.
- Follow R|E™ saturation, dwell time, and neutralization steps.
- Extract, wipe, or mop based on substrate, efficiency, and severity.
After fire remediation apply VaporLock to seal odors.
After water or biohazard cleanup apply Fortify to prevent microbial growth on the coating surface.
Exterior Surface Application
- Combine OxyPrep and Grease Gobbler in a 50/50 ratio.
- Follow R|E™ saturation, dwell time, and neutralization steps.
- Extract or rinse based on substrate, efficiency, and severity.
After cleaning, apply X4 for passive moisture control.
Documentation
OxyPrep SDS
TDS
PPE Selection Guide
OxyPrep NF Label
OxyPrep Fundamentals Guide
Reviews
There are no reviews yet.