A semi-transparent mold & moisture resistant coating used for the long-lasting protection of structural surfaces within the building envelope (i.e. “conditioned spaces”).
Applies and dries to a semi-transparent finish for quality control
Acts as a moisture barrier to prevent moisture content increases
Forms a tough, resistant barrier to moisture and contaminants
Tintable, Water-based and non-flammable
Product Info
SafeGuard is a semi-transparent protective coating for the long-lasting protection of structural surfaces in within the building envelope (i.e.“conditioned spaces”). Once cured, it forms a durable, “white wash” satin finish that is mold and moisture resistant. SafeGuard is breathable to prevent against wet and dry rot and allows for drying if saturated in the future.
*Treated Articles Exemption - This product contains an EPA registered antimicrobial to protect the coating from non-public health fungi and odor causing bacteria. No public health claims are being made.
Uses
All structural surfaces in soon-to-be conditioned areas (i.e. structural framing) and for post-remediation specifications
Surfaces
SafeGuard is used to protect most structural construction materials including treated and untreated lumber, plywood, OSB, particle board, cement board, wallboard, composite construction materials and metals. Probable areas of use are structural surfaces within the building envelope including warm-side sheathing, trusses, framing, joists, plates, pillars, posts, beams, gypsum board and backer board.
Safety
Consult SDS for details
Instructions
SafeGuard is formulated as a ready-to- use coating and should not be diluted. It can be applied with a brush, roller or airless sprayer to obtain an even finish. Do not apply past the point of run-off. A cross-hatching technique is the best way to ensure sufficient wet/dry film thickness and complete coverage. Consult the Enviroguard New Construction Warranty and Enviroguard Existing Construction Warranty documents for details.
Coverage Rate
For warranted best results, apply at 160 ft2 per gallon (800 ft2 per pail = 10 wet mils) based upon location, surface texture, porosity, age and application method. Does not include loss from over-spray or over-use.