Fortify MAINTENANCE

Even the best products have limitations. As protective coatings age, antimicrobial capacity and moisture resistance wane. Without maintenance, protective capacity degrades gradually to the point where moisture related issues can return. Simply fog apply Fortify according to the base coating's maintenance schedule and mold and moisture resistance will remain at peak levels.

Additionally. not every surface is practical to reach. When this occurs, Fortify can be used in it's foggable dilution to lay down an annual barrier of protection that inhibits seasonal mold conditions.

Use on structural and construction materials such as treated and untreated lumber, plywood, OSB, particle board, cement board, wallboard, composite construction materials and metals. Probable areas of use are structural surfaces within the building envelope including warm-side sheathing, trusses, framing, joists, plates, pillars, posts, beams, gypsum board and backer board.

Dilute 9 parts water to 1 part Fortify Concentrate. For best results, directionally fog onto surfaces to the point of run-off. One 5-gallon pail of Fortify Maintenance will yield 8,000 - 10,000 ft2 of coverage based upon location, surface texture, porosity, age and application method. 

Fortify should be applied directly to the surface to the point of saturation but not past the point of run-off. Once diluted, Fortify is a low viscosity sealant.  Apply the diluted solution of Fortify with a pump sprayer, fogger, electrostatic sprayer or airless sprayer (or any other similarly manual or powered equipment).

• For resurfacing Enviroguard Protective Coatings, use a 9-to-1 dilution (9 parts water to 1 part Fortify). Apply at a rate of 160 ft2 per gallon of ready-to-use solution. Coverage may vary due to surface texture, porosity, age and application method. This does not include loss from over-spray or over-use.